extend Your senses
cz en
A selected group of goods  Products »

TG 50
-50 to 350 °C (400 °C short-term)

Description and application

TG 50
-50 to 350 °C (400 °C short-term)

These right-angle, threaded resistance temperature sensorsTG 50 are designed to measure surface temperature of solid substances.

Due to right-angle temperature sensor design, the cable is led out at right angle to measuring part of the sensor and it enables to measure temperature just below the surface. To fasten the right-angle temperature sensor into a point to be measured, the thread is used. Maximum temperature range of sensor use is -50 °C to 350 °C (400 °C for a short period). The range for each design variant is reduced with a type of the temperature sensing element and the supply cable. The right-angle temperature sensors meet ingress protection from IP 50 to IP 67 according to the CSN EN 60 529 standard, depending on the supply cable variant.

The right-angle temperature sensors are intended for operation in chemically non-aggressive environment.


  • connectors


  • EC Declaration of Conformity – in accordance with Act 22/1997 Coll. on technical requirements on products as amended.
  • Calibration – The final metrological inspection – comparison with standards or working instruments – is carried out for all the products. Continuity of the standards and working measuring instruments is ensured within the meaning of the Section 5 of Act no.505/1990 on metrology. The manufacturer offers a possibility to supply the sensors calibrated in SENSIT s.r.o.’s laboratory (according to requirements of the EN ISO/IEC 17025 standard) or in an Accredited laboratory.  


  • Specifications
  • Modification
  • Wiring diagram
  • Dimensional draft
Sensor type TG 50
Sensing element All types
Case length L - measuring part
15 to 200 mm
Case diameter - measuring part
6 mm
Case dimension according dimensional draft
Case material stainless steel DIN 1.4301
Thread / OK M10 x 1 / OK 12
Supply cable variations / Temperature range
(can be limited by type of sensing element
– specified in manual)
PVC shielded -30 to 80 °C
PVC unshielded -40 to 105 °C
Silicone shielded -50 to 200 °C
Teflon shielded -50 to 250 °C
With fibreglass 0 to 400 °C (with metal braiding)
Ingress protection from IP 50 to IP 67 according type of cable
Insulation resistance (between case and sensor) >200 MΩ at 500 VDC, 25° ± 3°C
Maximum permissible static pull on the supply cable 1 kg

Note: Manufacturer reserves the right to make changes in design and technical characteristics of the products. For actual information, please always contact your dealer.

- possibility change the thread

- A class precision (with the exception Ni 10000/5000, Ni 10000/6180, T1 = Ni 2226, NTC 20 kΩ)

- possibility of dimension and material of the case

- variable spring length

Schéma zapojení
Rozměrový náčrt

Back to category